Thingiverse
DJI Phantom 4 Motor Cap
von jonbunker
76
Downloads
54
Likes
1
Makes
From a request for a motor cap for DJI Phantom 4- push fit cap.
I have compromised between strength and printability- it does seem to fit in the Phantom 4 case, but is very tight! There are lugs on the inside of the main ring to hold it in place if your printer has a fine setting.
Printed on a very old Afinia Up! (65minutes)
I have compromised between strength and printability- it does seem to fit in the Phantom 4 case, but is very tight! There are lugs on the inside of the main ring to hold it in place if your printer has a fine setting.
Printed on a very old Afinia Up! (65minutes)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
