DJI Smart Controller Harness Mount

This is a simple harness adapter utilizing the two M4 threaded holes on the bottom face of the DJI Smart Controller for the Mavic 2 (likely intended for a harness/etc in the first place which apparently DJI hasn't released as of this publishing). You will need two M4 machine screws at least 6mm in length but not longer than 12mm. One design is counter sunk for flat head screws and the other for button head.

The hole for the USB-C connector fits the one supplied with the controller which seems to be pretty chunky so it should work with just about any USB-C cable. There are also cut-outs for the speakers.

I did my best to draft and fillet the corners to match the fit on the controller using the fasteners I had on hand without removing too much material to compromise strength.

The part is sufficiently filleted to prevent stress cracking and failure but please print in a strong filament with good layer adhesion - PET at the very least - I would not print this in PLA as it is britt