Thingiverse
DMC 2 Coolant Nozzle
von jetsky98
2
Downloads
1
Likes
0
Makes
Setup information:
Printed in PLA.
Bed only supports -> so there is no support material in hollow tubes.
100% infill (solid).
Print time on Bambu X1 was 1h45m
Required hardware:
Qty 2 M6 x 10mm bolts
Qty 1 1/8" G thread push fit connector for 10mm hose (add a wrap of teflon tape)
Printed in PLA.
Bed only supports -> so there is no support material in hollow tubes.
100% infill (solid).
Print time on Bambu X1 was 1h45m
Required hardware:
Qty 2 M6 x 10mm bolts
Qty 1 1/8" G thread push fit connector for 10mm hose (add a wrap of teflon tape)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!