Thingiverse
DMT Duosharp Knife sharping jig
von dh1tw
14
Downloads
8
Likes
0
Makes
I never liked the stock holder of the DMT DuoSharp. Therefore I built a new one. The jig contains a few 3D printed parts and a wooden base.
With the help of four 608ZZ ball bearings the sled slides smoothly through the 5mm deep lanes. I milled the lanes with my small Makita router (DRT50Z). For the wood I used leftover multiplex.
The DMT Duosharp diamond plates are mounted on top of another 18mm high multiplex wooden support. I used M3 knurled thread nuts for fixing the plate holders.
The sled has an angle of 20° which I use for all of my kitchen knifes.
The Fusion360 file is attached.
With the help of four 608ZZ ball bearings the sled slides smoothly through the 5mm deep lanes. I milled the lanes with my small Makita router (DRT50Z). For the wood I used leftover multiplex.
The DMT Duosharp diamond plates are mounted on top of another 18mm high multiplex wooden support. I used M3 knurled thread nuts for fixing the plate holders.
The sled has an angle of 20° which I use for all of my kitchen knifes.
The Fusion360 file is attached.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
