Slicer Discord
DnD Screen-top Initiative Tracker – 3D-Druckmodell von MakerWorld MakerWorld
Board Games

DnD Screen-top Initiative Tracker

42 Downloads
7 Likes
26 Makes
Zum Modell
This is a redistrubtion of ShelfieSchtick's Screen-top Initiative Tracker.The only thing I have done is to add a profile so that it can be printed with the AMS. Full credit to the original creator.Text from ShelfieSchtick“SummaryLooking to replace the boring paper hangers I had been using for my D&D party, I set out looking for screen-top initiative systems that allowed for marking when a character's turn was done. I didn't find anything quite right, so (several iterations later) here we are!As combat begins, I call for initiative scores (in a Mercerian fashion) then place each flag in the array in the "down" position. That way there's some uncertainty about who goes when during the first round. On each turn, flip up the flag and off you go! During future rounds, I just start flipping flags down on each turn. The flags slot in at an angle, and the tabs at the bottom prevent them from coming back out unless you pull them up to the correct angle again. They also l
Kategorie
Board Games
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Warum?
2 Farben
Einteilig 2 Farben / AMS
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA, ABS
Farben
2 (AMS/MMU empfohlen)
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen