Dog boot drying rack with bottom

This model is based on the original dog boot drying rack. I added a solid bottom by introducing bottom shell layers so the rack can catch water, melted snow, and salt as the boots dry. This keeps runoff contained instead of dripping onto the floor or the surface underneath.I also scaled the model to the maximum size that fits on a Bambu Lab P2S build plate to improve stability and spacing while keeping it printable as a single piece.The airflow and drying behavior of the original design are unchanged. The top remains open to allow moisture to escape, while the added bottom makes the rack more practical for everyday winter use.I printed this in PLA without issues. If you plan to place the rack near a heat source such as a heat register, PETG is recommended.Print settings:Top shell layers: 0Bottom shell layers: 2Bottom shell thickness: 0.5 mmInfill: user preferenceExample shown uses Grid at 10%, but Honeycomb also works wellFunctionally the same rack, just less mess and happier floors/sh