Thingiverse
Dog Collar Holder
von LailanMatos
0
Downloads
0
Likes
0
Makes
Dog Collar Holder
- Recommended Layer Height: 0,2mm or smaller.
- Support: No
- Number of the Walls: 4
- Infill: 15% Rectilinear for more stability.
- Brim or raft not needed, You can use them if you dont have a good bed adhesion.
Assemble:
- Print the Model.
- Use a 3M to clue on wall
- Recommended Layer Height: 0,2mm or smaller.
- Support: No
- Number of the Walls: 4
- Infill: 15% Rectilinear for more stability.
- Brim or raft not needed, You can use them if you dont have a good bed adhesion.
Assemble:
- Print the Model.
- Use a 3M to clue on wall
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
