Thingiverse
Dog Flower Pot
por Kuvaszwhisperer
9
Descargas
19
Likes
0
Makes
Made a dog flower pot to hold roses for valentines day. My print didn't turn out to be water tight as I had my settings for speed, but no reason it can't be.
Used tree support for the snout from the chest, .5mm layer height, with a .6mm nozzle 5% infill.
Youll probably want more infill and a finer layer height if you want to end up with a water tight print. I've printed this model before with no supports if you use a smaller layer height.
Used meshmixer to add the Rose slots.
Used tree support for the snout from the chest, .5mm layer height, with a .6mm nozzle 5% infill.
Youll probably want more infill and a finer layer height if you want to end up with a water tight print. I've printed this model before with no supports if you use a smaller layer height.
Used meshmixer to add the Rose slots.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
