Slicer Discord
Dog Game – 3D printable model from Thingiverse Thingiverse

Dog Game

by bliki
2 Downloads
2 Likes
0 Makes
Go to Model
This is a fun dog game :-)

Three buttons that will randomly light up. If the dog pushes the right button the food wheel will turn and releases one of the goodies. A little tricky to learn but great fun.

The code is written so that when you start it up all three button's will light up. And every 5 sec the wheel will spin so you can put the food in. The moment you press one of the buttons the game will start. (Code is included)

The following hardware was used. As i used a 360 servo motor I needed another way to control to position. I used a magnet switch and six small magnets.

1 Black Psh button Mini Switch 6A-10A 110V 250V KCD1-101 2Pin Snap-in On/Off Rocker Switch 21MMx15mm
1 Arduino Nano
1 Pair Silver tone metal Battery spring plate set for AA AAA Batteries (If you want to make your own battery holder)
1 KY-024 4pins Liniar magnetic switch. (Hall Sensor module)
3 LED Light 60mm Arcade Video Game Player Push button Switches
1 SG-5010 Servo Motor 360 degrees.
3 MOSFET’
Source
Thingiverse
What you need to print this: Intermediate Low confidence
Single piece Hardware needed
Supports 1/3
Assembly 0/3
Settings 1/3
Bed size 0/3
Post-process 1/3
Printer
FDM / FFF
File format
STL
Material
PLA
Post-processing
Hardware
Software
Cura, PrusaSlicer, or similar
No ratings yet
No comments yet – be the first!

Similar Models

6 Suggestions
Feed Blog Slicer Cost Calculator Image Search Submit Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Add to Collection