Don't do it - Hot end

This is a dangerous thing the following reasons:

-It's made without any science.

- Nichrome around steel: many chances for a short sooner or later thus many chances for, at least, extruder controller death.

- It constantly leaks some baked-rebaked-ultrabaked abs (volume like a drop of water every... +/-10cc of extruded ABS), the fumes are everything BUT healthy.

The electrical failure plus catastrophe side is reinforced by a low mass design and thermistor most probably not placed in the right place. That leads this thing to the need of 255C degrees as a working temperature.

I never dared to upload this for all those reasons, however...
...I've noticed an increasing number of visitors in the place where the pictures for this thing are: http://aubenc.imgur.com/hot_end_aka_mk45 and I need to say again:

Don't do it!

Run the risk you want for your printer but, at least, think about the fumes of the baked abs!

I'm expecting this thing to fail... (some 3 months wokr