Donkey Car Mounting Frame

This model includes a frame to which a Raspberry Pi, servo controller and camera can be mounted to.

Includes mounting points for:
- Raspberry Pi Model 3B+
- Raspberry Camera Module V2
- Adafruit 16-Channel 12-bit PWM/Servo Driver (PCA9685)
(or components with similar hole placement)

Designed for HSP 94186 Brushed RC Car with dimensions 175 x 25 between cover hole centers

Brief:
- Print volume: 190 x 84 x 25 (main frame) and 86 x 30 x 17 (camera arm).
- Maximum bridge is 26mm long (approx. 1 in)
- 1mm wall/three perimeters is sufficient
- No supports required
- 13 M2.5 x 8-10mm bolts, 13 nuts and 2 washers required (3mm ID x 8mm OD)

Advantages:
- Easy access to SD card from top, power ports from sides
- Camera arm pivot
- Little material required and fast printing time
- Extra batteries can be mounted on top of the main frame
- The main frame can be mounted upside down if the camera arm is not required

Disadvantages:
- Ensure your ribbon ca