Thingiverse

Door Holder (Ball and Socket)

von dougeefresh

2.1k Downloads

1.6k Likes

0 Makes

Zum Modell

No latch. No slide. No hook. Just push to engage and pull to disengage!
Door holder to keep your door open (or HODOR!) when the door holder is pushed in.

If using PETG (Recommended)
=========================
- Use the standard version STL (Door-Holder-Socket.STL). The standard version printed using PLA will likely snap. See below if using PLA.
- Use high infill (80% or higher) since it will likely be exposed to abuse.
- Use the typical settings to increase strength (higher temp, low/no fan, etc.)
- You can probably print this in ASA or Nylon (not tested)
- The ball part is the same for both PETG and PLA.

UPDATED (10/3/2021)
- Recommended infill to 80%.
- Thicker flaps in the middle (~30% increase) for added strength.
- Wider opening (~0.8mm) to lessen stress put on the flaps.

If using PLA
=============
- Use the file with "PLA" at the end (Door-Holder-Socket.STL).
- The PLA version has deeper slots to give the flaps more flexibility.
- It also has a slightly

ball Ball and Socket ball joint door doorstop door holder door hook hodor holder indoor garden outdoor socket ball Ball and Socket ball joint door doorstop door holder door hook hodor holder indoor garden outdoor socket ball Ball and Socket ball joint door doorstop door holder door hook hodor holder indoor garden outdoor socket

Quelle

Thingiverse

Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz

Einteilig

Supports 1/3

Zusammenbau 0/3

Einstellungen 1/3

Druckbett 0/3

Nachbearbeitung 0/3

Drucker

FDM / FFF

Dateiformat