Door lock replacement part

Requires a spring about 9mm diam and 3-3.5cm long. I did use the one left from the broken mechanism I was wanting to repair. It is very important that the spring is always "compressed", even a little when the system isn't being used. The spring support must be placed with the openned part down to prevent the other piece to come out (and eventually locking you in/out).

Make sure to print it at 0.1 res or higher if you can. Supports needed.

Watch out, because this piece did fit on my mechanism doesn't mean that it's gonna fit on yours, so be careful and test it carefully before putting it back on your door. You don't want to be locked out, or in ;)