Thingiverse
door magnet
by Indianin666
9
Downloads
4
Likes
0
Makes
Door holding magnet.
10x3mm round magnets and two M3 15mm screws with nuts are needed to make them.
In my case spacers were necessary. V.2 was enlarged by 7mm to make it fit without pads.
10x3mm round magnets and two M3 15mm screws with nuts are needed to make them.
In my case spacers were necessary. V.2 was enlarged by 7mm to make it fit without pads.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
