Slicer Discord
Door nob wing lever – Modelo 3D imprimible de Thingiverse Thingiverse

Door nob wing lever

por shink
6 Descargas
8 Likes
0 Makes
Ver Modelo
A wing-like lever for opening the door without touching it.
It may also be useful for people who have difficulty grabbing a round knob.


You can use your wrist or lower arm to turn the knob to open the door instead of the palm of your hand.
The area is set a little wider so that it can be used not only for pushing but also for pulling.

Attach it to the round doorknob with M4 cap bolts.
Please note that it may crack if overtightened.
There is little friction between stainless steel and plastic.
If necessary, insert a small piece of double-sided tape into the gap.

When installing on the "push" side, adjust the angle so that it does not hit the door frame.

See the attached drawing for applicable doorknobs.
If it is a similar figure, use the slicer function to adjust the size.

M4 x 15 Cap screw ... 4
M4 nut ... 4
Double sided Adhessive tape ... if needed

I hope this wing will lead to your peace of mind.
Masks, hand washing, alcohol disinfection and social d
Fuente
Thingiverse
Lo que necesitas para imprimir: Intermedio Baja confianza
Pieza única Tornillería requerida
Soportes 1/3
Ensamblaje 0/3
Ajustes 1/3
Tamaño de cama 0/3
Postproceso 1/3
Impresora
FDM / FFF
Formato de archivo
STL
Material
PLA
Postprocesado
Tornillería
Software
Cura, PrusaSlicer o similar
Mismo diseñador, más plataformas

shink también publica en

2 modelos adicionales en 1 plataformas más

Verificado por coincidencia de títulos de modelos entre plataformas.
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!

Modelos similares

6 Sugerencias
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección