Thingiverse
Door Retaining Catch
by ZacSimmo
17.9k
Downloads
13.3k
Likes
19
Makes
A smaller version of my other latch, has a softer snap action and is generally smaller.
Print in place, no supports needed.
Update 14/01/2021:
Removed some material from the female side clip, it is now a little more snappy without being too strong.
Update 05/02/2021:
Please orientate the part so it prints flat on the print bed, this is important as it plays to the strength on printer layers instead of against them.
[](https://www.paypal.com/paypalme/zacsimmonds)
Print in place, no supports needed.
Update 14/01/2021:
Removed some material from the female side clip, it is now a little more snappy without being too strong.
Update 05/02/2021:
Please orientate the part so it prints flat on the print bed, this is important as it plays to the strength on printer layers instead of against them.
[](https://www.paypal.com/paypalme/zacsimmonds)
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
