Thingiverse
Door Slide Guide
von innomind
39
Downloads
35
Likes
2
Makes
This is a door slide guide that I designed in Solidworks. It uses three M3 holes for the screws to go into the floor to guide sliding doors in line. Print two of them to attach to the floor for both doors hanging parallel to each other.
This door guide is 100mm long, 20mm wide, and 30mm tall.
This door guide is 100mm long, 20mm wide, and 30mm tall.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
