Door stop and wall protector - command strip

Simple functional print that protects your wall from the door handle and keeps the door from swinging shut.I designed the backplate specifically to fit 4x Medium 3M Command Strips (1.3kg version). This gives a very strong hold without drilling holes in the plaster.How it works:Passive Locking: If you mount it about 1 mm above the door handle, you don't need to press the handle to lock it. Just push the door open, and the handle will slide under the arm and snap into place.Protection: Stops the handle before it hits the wall.Installation:Clean the print: Wipe the back of the printed part with IPA to ensure the strips stick perfectly.Apply strips: Stick 4 Command Strips to the print as shown in the photos. Important: Make sure the pull-tabs are pointing down so you can remove them later if you need to.Clean the wall: Wipe the wall spot with a dry microfiber cloth to remove any dust.Peel & Align: Remove the backing tape from the wall side of the strips. Align the model so the long arm