Door / Window Hinge

This is a work in progress to make a hinge compatible with raisers from [Ikea Lack raiser and window holder](http://www.thingiverse.com/thing:1814763)


It's heavily inspired by [Lack Table Enclosure Parts](http://www.thingiverse.com/thing:1227270), but redesigned from the ground.


This is a first try with Tinkercard after 15 years without doing any 3D modeling, so expect some improvements ;-)


The inner part of the hinge is a little bit loosy because it's 1mm smaller than the outer part as I didn't found a way to model shapes with decimal measurements with Tinkercad.

I did not remixed hinge from [this thing](http://www.thingiverse.com/thing:1831572) as I wanted to be able to remove the window easily.

This will fit M4 screws.