Thingiverse
Doorstop Handle
von kirbby
2
Downloads
9
Likes
0
Makes
I couldn't find a door stopper for the door handle, so the door handle doesn't bang against the wall and made my own.
This should be printed with flexible material.
You might have to adjust the infill, I needed 3 tries to hit a good amount so its not too hard and not so soft that it will break on harder impacts.
It prints quite fast 20-30mins so you can try a few times without using too much material.
If you printed this and it worked for you let me know and post a make. Thanks!
This should be printed with flexible material.
You might have to adjust the infill, I needed 3 tries to hit a good amount so its not too hard and not so soft that it will break on harder impacts.
It prints quite fast 20-30mins so you can try a few times without using too much material.
If you printed this and it worked for you let me know and post a make. Thanks!
kirbby veröffentlicht auch auf
21 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
