Thingiverse
Double Spinner Post and Caps
7
Downloads
6
Likes
0
Makes
Here is a twist on the spinner. Stack two spinners of any type (within reason/clearance) together on one shaft, add some caps, and you have something different.
Simple.
Shaft and caps are laid out at 8mm. Caps snap on nicely when I printed them. You may need to add a drop of glue depending on your printer.
The shaft MUST be a tight fit into the bearing or the spinners will wobble and contact each other, so you may need to scale up/down depending on printer and filament.
I use a Prusa MK2 and with .2 layers using BAM TACK filament, it is perftect.
I printed with no brim on the caps, and 2mm brim on the post.
I don't have any spinners, so I designed and printed 2 for the demo.
https://www.youtube.com/watch?v=DghUpOcaJkg&feature=youtu.be
Simple.
Shaft and caps are laid out at 8mm. Caps snap on nicely when I printed them. You may need to add a drop of glue depending on your printer.
The shaft MUST be a tight fit into the bearing or the spinners will wobble and contact each other, so you may need to scale up/down depending on printer and filament.
I use a Prusa MK2 and with .2 layers using BAM TACK filament, it is perftect.
I printed with no brim on the caps, and 2mm brim on the post.
I don't have any spinners, so I designed and printed 2 for the demo.
https://www.youtube.com/watch?v=DghUpOcaJkg&feature=youtu.be
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
