MakerWorld
Other Props & Cosplays
Model downloaden
Dr Doom - The Ultimate Nullifier
7
Downloads
9
Likes
5
Makes
This is the Ultimate Nullifier inspired by Marvel Comics, The Fantastic Four, and Galactus. I designed it for one of my own cosplays, Dr Doom. It is split into 8 pieces that all connect together. I recommend using a small amount of glue to keep it together, but the tolerances are very tight. *2mmx50mm rod is recommended as reinforcement on the small end piece on the bottom as the long shaft will be a weak point as just a 3d print. The part is split in 2 and should be glued together after the insert is added.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
