龙凤摇摆杯-Dragon and Phoenix Swinging Cup

Dragon and Phoenix Swinging Cup Features a rod and spring design that allows the cup to sway gently when you hold the base and move it. Perfect for gatherings, this cup is both a conversation starter and a stress reliever. Easy to assemble but requires glue for adhesion. Designed with a 0.2mm tolerance—if parts fit too tightly, sand them slightly. Before printing, make sure to clean the PEI build plate to maintain proper adhesion and ensure the filament is dry. The model uses approximately 300g of material and takes about 15 hours to print. For the dragon and phoenix parts, it’s best to use matte PLA filament due to the many supports—other materials may make support removal difficult. Recommended print settings: PLA, 0.12mm layer height, 2 wall layers, and acceleration set to 1000 or below. 龙凤摇摆杯 支杆弹簧设计，拿住底座移动时，酒杯可以轻轻摇摆。 聚餐专用的装13、解压酒杯，拼装简单，要用到胶水粘贴，0.2公差，太紧的打磨一下。 打印前记得清洁好PEI打印板，保证其粘度OK，确保材料干燥 模型用料300克左右，时长15小时左右。 龙凤最好用PLA哑光材料打印，支撑较多，其它的材料支撑不好拆。 PLA，0.12层高，2层墙，加速度全部1000或以下。