Slicer Discord
Dragon Dice Box with Hinge and Latch – 3D-Druckmodell von MakerWorld MakerWorld
Board Games

Dragon Dice Box with Hinge and Latch

405 Downloads
203 Likes
207 Makes
Zum Modell
MembershipBoost MeThis is my redesign of a model that was unable to be printed successfully. I carefully disassembled it and reassembled it with a greater opening of the lid to allow it to be printed without internal supports and work properly. Please check your slicer to ensure there are supports under each hinge. I personally didn't have this issue but someone did and rated it 4 stars…. the other note was that the support can be difficult to remove from under the left wing. If you aren't careful this can cause it to lose the tip. Please like and RATE this model! We love seeing your result so please come back and share a photo when you're done! If you'd like to buy me a coffee to support this and future projects https://www.popsession.co.nz/products/buy-faran3d-a-nuka-cola
Kategorie
Board Games
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Warum?
Supports nötig
Einteilig Supports nötig
Supports 2/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen