Cults3D
€ Paid
Home
Zum Modell
Dragon Egg
0
Downloads
0
Likes
0
Makes
Instead of using threads to fasten the egg together, this model uses magnets! The small baby dragon will fit inside!
Print Instructions:
Required Hardware:
6 - 6x3mm magnets for the egg
Supports: Not required. However, if you want the inside of the egg to look neat toward the top you might consider adding support there if you'd like.
Assembly:
When placing the magnets, ensure the magnets placed in a way where they attract each other when the tray is attached to the pot.
Happy printing!
Feel free to join [my discord](https://discord.gg/uqJwERhbxf) for additional support, questions, or suggestions!
Print Instructions:
Required Hardware:
6 - 6x3mm magnets for the egg
Supports: Not required. However, if you want the inside of the egg to look neat toward the top you might consider adding support there if you'd like.
Assembly:
When placing the magnets, ensure the magnets placed in a way where they attract each other when the tray is attached to the pot.
Happy printing!
Feel free to join [my discord](https://discord.gg/uqJwERhbxf) for additional support, questions, or suggestions!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
