Thingiverse
Dragon Knob
von lceDog
2
Downloads
0
Likes
1
Makes
This is a knob for a windup toy. The knob is for a .100" square shaft, and fits inside a Ø.350" hole.
The bottom of the square hole is equal to the last 3 digits listed in the filename. (Adding spaces or tabs didn't work to line up the columns so I used dots to line them up).
Width at bottom of hole.......... Width at Top of Hole
094 ........................................ .107
104.......................................... .117
114 ......................................... .127
The bottom of the square hole is equal to the last 3 digits listed in the filename. (Adding spaces or tabs didn't work to line up the columns so I used dots to line them up).
Width at bottom of hole.......... Width at Top of Hole
094 ........................................ .107
104.......................................... .117
114 ......................................... .127
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
