MakerWorld
Sculptures
Go to Model
Dragon Skull
168
Downloads
152
Likes
78
Makes
Hi guys, hope you like this new Dragon skull:) Feel free to scale it if you would like to print it bigger or smaller. I recommend to use pliers to carefully remove the support. I usually grab the support rather close to the connection, slightly wiggle it around to loosen it before pulling it off:) There is a hole in the back for wall mounting this sculpture:) If you would like to sell prints of my models check out my commercial license my Patreon: https://www.patreon.com/c/TreeDprintsAlso check out my other models here: https://makerworld.com/en/@TreeDprints
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
