Dragon - Tail for Seeds

3D Printed Dragon Tail for Seeds

6/6/2025 - Version 1
Continuing on with making props, I present a Dragon Tail for seeds.
The holes are made for simple/cheap three wire epoxy white seeds. Picture is provided of the type of seed in the project files.
The seeds that fit the holes is shown in the uploaded picture. Basically, it uses, the classic white epoxy seeds on 3 wires.
While it is made for the smaller seeds, I do believe you could use bigger pixels but place them on the "back side" of the prop.

Description:
It is composed of 22 separate pieces. (there are 2 test pieces used to test print and don't attach to the present).
Most pieces are 6mm thick with a 2mm thick raised edge that is 10mm high.

Its approximate size is 1183mm wide x 493mm high (47in x 20in).
It holds 227 pixels.

As for mounting, I did not place mounting holes as the pixels are quite dense and anticipate one set of holes isn't going to really help anybody. Let me know.
If you are looking for mounting hard