Dragonfly Science V2

Adjusted for printing with slic3r.

BODY:
I cut body in 1/2 so no supports needed. Eye hex and crank holes were made larger.

Clean up the body half's & front 3 crank holes first (1/16" bit). Glue the eye section with crazy glue, then glue the tail next. Install the crank. Glue near the crank holes & wing pivots although this is not necessary.

The crank was formed with a 1 mm paper clip & needle nose pliers. The offset was made with a 1/8" nose, the journal was made with a 3/16" nose. Center offset is 1/4".

File the wing pivots to be around 2.8 mm in diameter. Being this is not intended to fly, I used a second 1 mm paper clip for linkage and hand crank. Check the tail hole for fit up and adjust as required. You can used a #57 drill bit if necessary.

WINGS:
Pivot hole was relocate & legs made larger for more strength. Slow the speed to 15 to 20% when getting to the wing legs. 10% 1,3,3,3 with 1 raft. Clean the pivot hole with a 1/8" drill bit & inside of l