Thingiverse
Drain Cover for 3" pipe
por mrspiffy
0
Descargas
0
Likes
0
Makes
We needed a low profile drain cover, so we printed one!
The trick to this is to have 0 top and bottom shells/layers and increase the wall loops to make the sides solid (around 8). Pick hexagon fill and the size of the hole is related to your fill percentage. I recommend 15%.
USE ABS OR NYLON. Pla wont cut it outside.
2nd photo is the size of the drain pipe this was designed to go over. Slips right on.
The trick to this is to have 0 top and bottom shells/layers and increase the wall loops to make the sides solid (around 8). Pick hexagon fill and the size of the hole is related to your fill percentage. I recommend 15%.
USE ABS OR NYLON. Pla wont cut it outside.
2nd photo is the size of the drain pipe this was designed to go over. Slips right on.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!