Thingiverse
Drawer Holder Under Sink
door wnnorton
41
Downloads
42
Likes
0
Makes
Installed a new sink. Was a little bigger than the old model. The drawer face that I have tilts out and had some plastic bins attached. Created these to reduce the thickness so that the drawer could close easily.
Printed with 0 bottom or top layers to create the grid on the bottom so stuff doesn't stay trapped in these.
Printed with 0 bottom or top layers to create the grid on the bottom so stuff doesn't stay trapped in these.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!