Dreame (Xiaomi) nozzle

Dreame stick vacuums are not always supplied with a simple, brushless, nozzle. Now you can print one.Designed in two parts (plates), to fit 10 inch printers, then glue together.If you printer is not calibrated, print first 5mm of the nozzle part to check tolerances. If bad fit adjust parameter “X-Y contour compensation”. Print in PLA plus, PETg or better filaments. The release button is the “sensitive part”, which needs to be able to flex a bit. Fine-tune with knife on the areas marked red in picture. V2: Design of hole around release button improved, to avoid having to do clean-up. Credits to feedbacker “Stopperan”…Enjoy! Feedback is welcome.