Dreamer external filament kit

I had a lot of spools to big to fit in ´side the dreamer and I hate just lifting the lid of and dragging the filament direct down..
Cause when I need to print ABS all of a sudden.. I have to cut both filaments to put the lid on..

This was my sulotion..
I share this full kit..

All you need is sip ties and PTFE tube..

IMPORTANT!!
Use the same tube as the one that comes with the dreamer.. that would be:
3mm inside and 4mm outside..
I tried with 2mm inside from a bowden extruder.. but there was to mush friction!..