Thingiverse
Dremel 300 Support
by AT_3D
43
Downloads
33
Likes
0
Makes
A support for an indispensable tool, the dremel 300.
This small support allows you to simply put the dremel and some accessories on his desk or workbench without losing too much space.
It is of course perfectible, I just created it and if I make changes I will send them to you ^^
All your remarks are good to take.
To maintain all that I used M8 threaded rods and M8 nuts:
2 threaded rods M8 17cm
10 nut M8
I post an image to explain the assembly
This small support allows you to simply put the dremel and some accessories on his desk or workbench without losing too much space.
It is of course perfectible, I just created it and if I make changes I will send them to you ^^
All your remarks are good to take.
To maintain all that I used M8 threaded rods and M8 nuts:
2 threaded rods M8 17cm
10 nut M8
I post an image to explain the assembly
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
