Thingiverse
Dremel Tool Holder Collet
by dreamsinbits
290
Downloads
168
Likes
1
Makes
I wanted to weld my prints with my Dremel, but I had no tool holder that fitted 1.75mm filament, so I designed one.
With this tool holder you can take a bit filament and clamp it into the Dremel tool, when you press the rotating filament onto your prints you can weld them. This is because the resulting friction causes heat.
I discovered this procedure here: http://hackaday.com/2014/12/30/3d-printing-technique-friction-welding/
With this tool holder you can take a bit filament and clamp it into the Dremel tool, when you press the rotating filament onto your prints you can weld them. This is because the resulting friction causes heat.
I discovered this procedure here: http://hackaday.com/2014/12/30/3d-printing-technique-friction-welding/
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
