Drill dust collector

*** Hands-free Wall Drill Cup ***

*For collecting dust from a drill bit during drilling into plasterboard*

* No supports
* No adhesion required (rafts/brim)
* Print in-place
* Thin (low PLA usage)

This Thing is a simple drill dust collector designed to be stuck to a painted plasterboard wall with wide masking tape. With one flat edge it can be as close to the wall as possible and the masking tape can prevent dust going down the small gap as well as leave it hands free. If you don't trust the adhesiveness of the tape you can always hold it in place as well or perhaps use blutack etc on the bottom edge for extra support

Yes, you could also just do the same thing with a cardboard box or something but this Thing is spherical to give maximum collecting radius and this is also reusable.

You could use it for other drilling surfaces although you'd have to hold it in place with your non-drilling hand.