Drill paint mixer V3 - Final version

Hello, Here is our new model and final version, a paint mixer V3 for drill. You have 3 types of mixers, choose the one that suits you best and print one holder and you are ready. The new V3 model is bigger than the first ones,it comes in two parts, which allowed us to make the total length of the mixer 320mm. Below in the picture you can see the exact dimensions of the model The profile is adjusted for optimal printing. The stem is in the position where it is most rigid for use. You have a hole in the stem and the mixer, through which you pass a piece of filament after printing to ensure that the stem does not fall. In the picture below you can see where the filament goes. Easy print, without support. Works fine and mix paint and epoxy fine. When printing with PLA, it is recommended to leave the front door open on the P1 and X1 models to allow for good cooling. And don't forget to boost our models for more usefull models ;) Enjoy printing :D