Thingiverse
Drill Press Pipe Holder/Guide
por Add_Em
1
Descargas
5
Likes
0
Makes
This is a cross-cut jig/holder for conduit, PVC, or any kind of pipe. It comes with a small insert that centers the jig on your drill press table. Once centered, you can clamp or screw the jig down to the table and hold a pipe with it. This jig allows you to drill perfect cross-cuts in pipes.
There are 2 sizes
Smaller: 7/64" - 3/4" drill bits
Bigger: 1/4" - 1 1/4" drill bits (centering insert works well with a 1/4" pilot drill bit)
Both sizes have a support piece for the other side of the pipe
Supports are recommended to make the centering insert smoother.
There are 2 sizes
Smaller: 7/64" - 3/4" drill bits
Bigger: 1/4" - 1 1/4" drill bits (centering insert works well with a 1/4" pilot drill bit)
Both sizes have a support piece for the other side of the pipe
Supports are recommended to make the centering insert smoother.
Add_Em también publica en
8 modelos adicionales en 1 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
