Thingiverse

Drillable Centrifugal Fan

by Bionicarm

12 Downloads

11 Likes

0 Makes

Trying to build a small blower for a moderate flow and pressure system. I've had good luck with straight vane blowers in the past so I tried out NamorIt model. Had to adjust it a bit to fix an issue with non concentric platform and to fill in the hole. I left a small hole in the middle to guide a drill bit allowing you to drill it out as needed. I'm a bit of a hybrid, I like to print parts and then adjust them to fit and add to another project.

If you set it down a bit in Cura you don't need supports, otherwise if you need the flanges on the back you can print with supports as normal.

Source

Thingiverse

What you need to print this: Intermediate Low confidence

Why?

supports needed

Single piece Supports required

Supports 2/3

Assembly 0/3

Settings 1/3

Bed size 0/3

Post-process 0/3

Printer