Drink Carrier

The Bevy Bim!Full print can hold 10 beverages each with a 74mm diameter or less (soda cans, bottles, water bottles, energy drinks, snapple, body armor, etc..). You can just print the center holder and the handle if you don't want to carry any more than 6 drinks.You will need 1 - M5x32 countersunk screw and a single M5 nut to hold the handle to the center drink carrier. It gets heavy when it is full with 10 drinks (also print is approx 1kg all together) so I didnt want to make it a “no hardware” print and risk it breaking after a few uses. The 2 side extension pieces slide in to place without hardware. Tolerances are a bit tight because I didn't want it to wobble at all or come apart, so I have included a tolerence testing plate (4th plate). assembly should be pretty easy and straightforwrd, the M5 nut needs to be pushed in all the way in its slot on the handle with something small like a small hex wrench.The 2 extension pieces have a very small piece of support material at the