Drink holder

NOTE: Marked as WIP, haven't been printed and tested yet but i don't see any problems if printing it. Just be aware that its an untested design at the time.

A drink coaster that will help you to not spill your drink :)

Please take care to printing orientation to make it as strong as possible.
Picture with recommended orientations. (if you have a better way for stronger parts please share, thanks).

When joining top and ring parts please use an m5 locknut and bolt with 4 washers. If you dont tighten to mush the tray should be able to swivel thanks to the washers.

Also glue is very much recommended to make sure not to drop any drinks and getting sad when your whiskey covers the floor.

There are a few rings to ensure your drink stays in center with most bases. (If you need a new size just ask and i will get to it, or just remix like crazy if you feel like it)