Drinks can holder with hook

*** Drinks can holder with hook***

I made this thing because I was irritated that when in a comfortable position in my garden "egg" chair I couldn't reach a table or anything so if I had a drink I couldn't put it down. First World problems right there.

This Thing will print:
- in place / one piece
- without supports
- without adhesion

Features:
- Allows drainage / prevents pooling of liquids
- Hanging hook
- Perhaps also insulates a little bit keeping it cool (not tested, let me know in the comments)

The holder prints upside down, in one piece without supports or raft etc. It takes about 5 hours to print on my Ender 5 Pro. There are four feet inside the holder, this is so it can print upside down and stop the can falling through, so although the feet are angled, this is intentional for the print and doesn't affect the can because of the cylinder. Also it means that it doesn't collect drink if any is spilled, thus annoying you every time you take a swig. If you want it