Dripper Sprayer

I created a sprinkler head that fits into my irrigation dripper lines, this size seems to fit well into the hose line. I use a Resin 3d Printer so when it was complete I used a Air compressor to blow out any Resin lodged inside before Curing. Make sure no resin is inside before curing. It prints in place no supports. :) The stake is a bit short, but I figure not all people can print super tall in resin. You could put the stake side ways I guess on other printers. This is my first file uploaded so hopefully no problems arise for you guys. The holes are fairly small which A resin printer would be fine with. .05 mm thickness. probably be fine at higher layer thickness? You could print 4 or so at a time and it gets done fast. the stake adds a lot of time, might want to bypass, there are stakes out there that you get from home depot that grab onto the water line if you don't want to print it for hours.