Slicer Discord
drive caddy for phanteks enthoo evolv – 3D-printbaar model van Thingiverse Thingiverse

drive caddy for phanteks enthoo evolv

door Mrcleanr6
11 Downloads
8 Likes
0 Makes
Model downloaden
here is another hard drive option for phanteks enthoo evolv case. my main case area was loaded with water cooling so i lost the 5 additional hard drive spots leaving me only the 2 in the basement of the case. this one will mount a 3rd hard drive vertically between the glass side panel and the back panel of the case just above the basement hard drives. the 2 holes on the right are for the screws that hold the 2 lower wire straps. you need to remove those straps and just use tywraps.

if you have a smaller sized power supply then you can use the other drive caddy i posted for mounting in the basement of the case.
Bron
Thingiverse
Wat je nodig hebt om te printen: Gemiddeld Lage betrouwbaarheid
Eendelig Hardware nodig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 1/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
Nabewerking
Hardware
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie