Thingiverse
Drive for Paddleboat
by Vanny
4
Downloads
6
Likes
0
Makes
This is made for Racerstar BR2205 Motors or same sized ones.
You will need 3 Bearings 8x5x2 mm on each side.
I used M5x70 nylonscrews as axle.
Print the two gearparts with 3 perimeter, all other with 2.
infill not less than 50%.
I used PLA.
Still WIP, so didn´t finish building. ....to be continued...
You will need 3 Bearings 8x5x2 mm on each side.
I used M5x70 nylonscrews as axle.
Print the two gearparts with 3 perimeter, all other with 2.
infill not less than 50%.
I used PLA.
Still WIP, so didn´t finish building. ....to be continued...
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
