Thingiverse
Driver for the Wraith
by 3D_ThingKing
123
Downloads
78
Likes
0
Makes
Driver for the Wraith
I placed him on his back chopping half his back and arse off so it would fit the chair in the car without problems. I suggest you do the same. I also had to postprocess away some material on his right side. Namely some lovehandle, ass and lower thigh. And while you are at it loose his feet too. Otherwise an ok fit!
Check the film clip to see
https://youtu.be/q9nZoe2giFI
I placed him on his back chopping half his back and arse off so it would fit the chair in the car without problems. I suggest you do the same. I also had to postprocess away some material on his right side. Namely some lovehandle, ass and lower thigh. And while you are at it loose his feet too. Otherwise an ok fit!
Check the film clip to see
https://youtu.be/q9nZoe2giFI
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
