Thingiverse
Drone Camera Gimbal
von Azkarel
7
Downloads
10
Likes
0
Makes
Hello all,
To complete the gimbal, I have used 2 Turnigy TG9e servos to drive the model.
3mm steel axis with brass tube 4/3mm diameter has been used as bearings.
To drive the servos, in this moment they are connected to a Naza 2 flight controller, but it could be drive by an arduino1 + MPU6050.
Anchoring system is prepared to be connected with a standard GO-Pro or similar base.
Thank's for watching.
To complete the gimbal, I have used 2 Turnigy TG9e servos to drive the model.
3mm steel axis with brass tube 4/3mm diameter has been used as bearings.
To drive the servos, in this moment they are connected to a Naza 2 flight controller, but it could be drive by an arduino1 + MPU6050.
Anchoring system is prepared to be connected with a standard GO-Pro or similar base.
Thank's for watching.
Azkarel veröffentlicht auch auf
1 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
