Thingiverse
Drone Gimble Stand
von that3dstore
9
Downloads
6
Likes
0
Makes
Simple design with a nice shape to keep you drone gimble on show when not in use.
The pitch is 55mm to fit 12mm carbon rod undercarriage.
Added: SJ4000 Camera Dummy
To use as both a test model and to sit in the gimble as display when the camera is used else where.
Has a 15 x 35mm hole in the center to allow you to set the weight with washers or sinkers. I used a piece of Brass rod cut and hot glued in place.
The pitch is 55mm to fit 12mm carbon rod undercarriage.
Added: SJ4000 Camera Dummy
To use as both a test model and to sit in the gimble as display when the camera is used else where.
Has a 15 x 35mm hole in the center to allow you to set the weight with washers or sinkers. I used a piece of Brass rod cut and hot glued in place.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
