Thingiverse
#Drone Quadcopter
por plaszlonet
965
Descargas
858
Likes
7
Makes
https://www.youtube.com/watch?v=XnAsO8CUk4E
Printed whit 0.3 nozzle at 1.2 shell 15% infill at 0.2 height, pla at the moment, the aluminium tubes 16 mm diameter the mounting holes for the screws m5 and m4, on the canopy used m4 for the arms used m5 type D nuts for wood screw in, heat them up a bit then just fillet them into the plastic (try on something else first) attention the m4 ones are zinc so if you over heat them they melt :) http://www.ebay.co.uk/itm/191750463922?_trksid=p2057872.m2749.l2649&var=490769878848&ssPageName=STRK%3AMEBIDX%3AIT
http://www.ebay.co.uk/itm/181423591282?_trksid=p2057872.m2749.l2649&var=480397797307&ssPageName=STRK%3AMEBIDX%3AIT
Printed whit 0.3 nozzle at 1.2 shell 15% infill at 0.2 height, pla at the moment, the aluminium tubes 16 mm diameter the mounting holes for the screws m5 and m4, on the canopy used m4 for the arms used m5 type D nuts for wood screw in, heat them up a bit then just fillet them into the plastic (try on something else first) attention the m4 ones are zinc so if you over heat them they melt :) http://www.ebay.co.uk/itm/191750463922?_trksid=p2057872.m2749.l2649&var=490769878848&ssPageName=STRK%3AMEBIDX%3AIT
http://www.ebay.co.uk/itm/181423591282?_trksid=p2057872.m2749.l2649&var=480397797307&ssPageName=STRK%3AMEBIDX%3AIT
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!