Thingiverse

Drone Timer (PIDFlight ESP32)

by eried

24 Downloads

21 Likes

0 Makes

What it is?
======
It is a timer for your fpv drones and whoops.

How does it work?
======
It uses the video transmission signal to estimate the position of the drone, so no new hardware needed on the drones. You calibrate the signal in a certain "gate" and then track your lap times with it.

_____________________________

Make one
======
Print the case and order the parts. You have to superglue the switch slider parts. The two teardrop-shaped holes need to be filled with some translucent material. They difuse the ESP32 T8 leds, I used a 3d pen and translucent PLA as you can see in one of the photos.

Check https://github.com/eried/pidflight-lap-firmware for more details.

### ** Parts **

* ESP32 TTGO T8 https://s.click.aliexpress.com/e/_d6sfNUb
* RX5808 https://s.click.aliexpress.com/e/_dUaM1rh
* 2x 4.7K resistors
* Small battery (optional) i.e.: https://aliexpi.com/ZSsn
* Buzzer (optional) https://s.click.aliexpress.com/e/_d75AAWT

### ** Software **

It u

Chorus Chorus RF laptimer drone esp32 fpv fpv racer LapTimer laptop pidtimer Quadcopter RX5808 timer Chorus Chorus RF laptimer drone esp32 fpv fpv racer LapTimer laptop pidtimer Quadcopter RX5808 timer

Source

Thingiverse

What you need to print this: Intermediate Low confidence

Single piece Hardware needed

Supports 1/3

Assembly 0/3

Settings 1/3

Bed size 0/3

Post-process 1/3

Printer

FDM / FFF

File format